Searching the SMB Server From the Browse List
Procedure
1
Perform Step 1 through Step 2 from Sending to a Registered SMB Server.
2
Press [Input Address].
You can select destinations by pressing the register name from the destination list. For details about selecting a registered destination, refer to Sending to a Registered SMB Server.
3
Press [Browsing].
The browse list for the network appears.
4
Select a workgroup name, and then press [Down].
When the list consists of more than one page, press [Previous] or [Next] to move to the target page.
The maximum number of workgroups that can be viewed is 512.
5
Select a computer name, and press [Down].
When the list consists of more than one page, press [Previous] or [Next] to move to the target page.
To move to the higher-level layer, press [Up].
The maximum number of computers that can be viewed is 512.
6
On the authentication screen, press [Change] for both [Login Name] and [Password], and then enter the credentials.
For details about entering text, refer to Entering Text.
7
Press [Login].
8
Select a destination folder, and press [OK].
To move to the higher-level layer, press [Up].
The maximum number of folders that can be viewed is 256.
If the file path length exceeds the maximum number of characters (255 single-byte characters/127 double-byte characters), it can be adjusted so that the file path fits within the maximum.
9
Press [Scan Settings].
The [Scan Settings] screen is displayed.
Press [Register] to register the address you entered.
You can register up to 150 SMB destinations. For details about registering a destination, refer to [Scan Address Register].
10
Perform the steps on Sending to a Registered SMB Server from Step 5.
in the upper-right of a page, it turns into 
and is registered as a bookmark.