Interrupting and Copying
Overview
Pressing Interrupt on the Control panel when outputting a job interrupts the job currently being executed, and allows you to prioritize another copy.
This is effective if you want to perform a copy using a different setting temporarily while the machine is operating.
Tips
- You can specify the timing for when the interrupt operation is performed after pressing Interrupt. Select [Stop Immediately] or [WhenCurrentComp.] in [Interruption Suspend Setting]. For details, refer to [Interruption Suspend Setting].
It is not possible to interrupt if any of the following conditions apply.
- When you are performing a batch output or scanning an original document
- The machine is currently being serviced or there is an issue such as a paper jam
- You are making a copy in interrupt mode
- When a priority output job is being executed or when a priority output job is in the reserved job list
The following functions cannot be used when interrupting.
- Copy reservation
- [Auto Low Power]/[Auto Shut OFF]
Procedure
1
Press Interrupt on the Control panel.
The Interrupt LED flashes until the system is ready for the interruption.
2
Check that interruption has been made available.
If interruption is available, [Ready to copy] is displayed in the message display section, and the Interrupt LED flashes. The [COPY] tab is changed to the [INTERRUPT] tab.
3
Set the target copy conditions.
When [Interruption Suspend Setting] is set to [Stop Immediately], you cannot specify [Application].
When [Interruption Suspend Setting] is set to [Stop Immediately], you cannot recall settings registered in Copy Mode Memory.
4
Position the original.
5
Press Start on the Control panel.
The interrupt and copy operation is executed.
The interrupt operation is displayed at the top of the [Reserved Job] in the [JOB LIST].
6
Press Interrupt on the Control panel when the interrupt and copy operation is complete.
The interrupt and copy operation is completed and the pre-interrupt operation is resumed.
Interrupt Mode is not automatically canceled when the interrupt and copy operation is complete, but it is canceled if the auto-reset function is enabled.
in the upper-right of a page, it turns into 
and is registered as a bookmark.