Operation Workflow
Procedure
1
Position the original.
Load the original document which is to be copied on the ADF or Original glass.
2
Press [COPY].
3
Set the copy conditions.
For details about copy conditions, refer to Configurable Settings on the [COPY] Screen.
4
Enter the number of sets using the Keypad of the Control panel.
Proceed to Step 9 when scanning the original in one go.
Proceed to Step 5 when dividing up the scan of the original into multiple parts.
5
Press [Separate Scan].
This starts [Separate Scan] mode. [Separate Scan] may already be selected depending on the configured copy conditions.
Use the [Separate Scan] function to scan when scanning multiple originals using the Original glass or if you have exceeded the maximum number of sheets for the ADF.
6
Press Start on the Control panel.
This scans the original.
7
When the original has been scanned, switch it with other original(s), and press Start again.
This scans the next original.
8
When all originals have been scanned, press [Separate Scan] again.
This exits [Separate Scan] mode.
9
Press Start on the Control panel.
Copying starts. A dialog box confirming the next job reservation is displayed.
The job reservation dialog box disappears automatically when the copy operation is complete. You can also make the dialog box disappear by pressing [No].
This completes the copy operation.
Proceed to Step 10 if you want to reserve a job.
Proceed to Step 11 if you want to cancel a copy job.
10
Press [Yes].
This allows you to reserve the next job to be copied. Operates in the same way as with regular copying.
11
Press Stop on the Control panel if you want to stop a copy operation.
This pauses the job that is currently underway and displays a dialog box.
12
Select the method for stopping the job.
[Cancel Job]: The job is canceled. All of the scanned data is erased.
[Continue]: The job is continued.
[Temporary Stop]: The job is temporarily paused. To restart the job, press Start on the Control panel. The originals which have not yet been scanned are temporarily paused and remain in the ADF.
[Stop at a Set]: Temporarily pauses the job when a set of copies has been completed. To restart the job, press Start on the Control panel. If there are originals which have not yet been scanned in the ADF, the originals are all scanned and all information scanned is output upon restarting.
in the upper-right of a page, it turns into 
and is registered as a bookmark.