[FD-Mag. Adjustment]
Overview
Adjust the magnification in the paper feed direction when using the ADF.
Scanning accuracy is maintained by making regular adjustments.
NOTICE
- To make correct adjustments, configure the following setting in advance.
- Perform [FD-Mag. Adjustment] in [Printer Adjustment].
Reference
- For details about [FD-Mag. Adjustment] in [Printer Adjustment], refer to [FD-Mag. Adjustment].
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel, Control Panel | |
Printer driver | - | ||
Application | - | ||
Required options | - | ||
Required items | - | ||
Setting items | [Current Data] | Displays the adjustment value of the current magnification in the paper feed direction. | |
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [ADF Adjustment] - [FD-Mag. Adjustment] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [ADF Adjustment] - [FD-Mag. Adjustment] | |||
Procedure
1
Press [Print Mode].
2
Load A4 paper into the paper tray, and select that paper tray.
3
Place a test chart in the ADF tray, and press Start on the Control panel.
The test chart is scanned and a sample is printed out.
Load the test chart with the front side facing upward.
4
Measure the length in the paper feed direction, and compare the measured value with the chart.
Standard value: 0 mm ^ 1.0 mm
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1%]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.