[Z-Fold Position Adjustment]
Overview
Adjust the fold positions for Z-folding.
Make this adjustment when the fold position deviates from the standard value.
Tips
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required items | Finisher FS-532 with Z Folding Unit ZU-608 mounted | ||
Setting items | [Fold 1] | Adjusts the 1st fold position. | |
[Fold 2] | Adjusts the 2nd fold position. | ||
[Offset for All Size] | Adjusts the fold position common to all the paper sizes. | ||
Paper size selection key | Selects the paper size to adjust. | ||
[+] / [,] | Switches the paper size page. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Z-Fold Position Adjustment] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Z-Fold Position Adjustment] | |||
Procedure
1
Press the selection key of the paper size to adjust.
2
Press [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
[Output Setting] is automatically set to [Z-Fold].
4
Press Start on the Control panel.
A sample is output.
5
Check lengths "a" and "b" of the output paper.
Paper size | Standard value a | Standard value b |
|---|---|---|
[A3w] | 4 ^ 2 mm | 209 mm or less |
[B4w] | 4 ^ 2 mm | 181 mm or less |
[11e17w] | 4 ^ 2 mm | 215 mm or less |
[8.5e14w] | - (half-fold only) | 241.7 mm or less |
[8Kw] | 4 ^ 2 mm | 194 mm or less |
Standard value "b" shown in step 5 is changed even if either position of [Fold 1] and [Fold 2] is changed.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
When adjusting both [Fold 1] and [Fold 2], first adjust [Fold 1]. [Fold 1] is used as the reference position of [Fold 2].
7
Select [Fold 1].
8
Use the on-screen keypad to enter the numeric value.
To change [Current Data], use [+ / -] to select the plus or minus of the numeric value, and press [Set].
[Adj. Range:-128~+127 1step = 0.1mm]
9
Select [Fold 2].
10
Use the on-screen keypad to enter the numeric value.
To change [Current Data], use [+ / -] to select the plus or minus of the numeric value, and press [Set].
[Adj. Range:-128~+127 1step = 0.1mm]
11
Repeat steps 2 to 10 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.