[Highlight Adjustment]
Overview
Change the gamma curve and manually adjust the gradation and background density of the highlighted part.
Adjust if the gradation density reproduction of the highlighted part differs for each screen.
NOTICE
- Following settings are required to use this function.
- Run [Gamma Automatic Adj.].
Tips
- If you want to make an automatic adjustment, adjust it using [Highlight Automatic Adj.]. For details, refer to [Highlight Automatic Adj.].
Reference
- For details about [Gamma Automatic Adj.], refer to [Adjustment / Maintenance].
Specifications
Category | Print Workflow, Adjustment / Maintenance | ||
Location | Machine | Control Panel | |
Printer driver | - | ||
Application | - | ||
Required options | - | ||
Required items | - | ||
Setting items | Keypad | Used to enter numeric values. | |
[+ / -] | Sets the plus or minus of the numeric value. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the on-screen keypad or the Keypad of the Control panel to [Current Data]. | ||
[Previous] | Switches the screen to be adjusted. | ||
[Next] | |||
[Print Mode] | Prints the chart to be used for measurement. | ||
[Return] | Moves to the previous screen. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Quality Adjustment] - [Highlight Adjustment] | ||
Procedure
1
Press [Next] or [Previous] to select a screen to be adjusted and then press [Print Mode].
2
Set A4 v paper and select the relevant paper feed tray.
3
Press Start on the Control panel.
A chart is output.
4
Press [Exit PrintMode] to return to the setting screen.
5
Check the output chart.
Check that the highlight area begins between the gray reference lines [1].
6
If any adjustments are required, select the key for the color you want to adjust and enter the values using the on-screen keypad or using Keypad on Control panel.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-128~+127]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.