[Operation after Deviation/Out of Range was Detected]

Configure actions for when image deviation or a non-standard image is detected.

For details, refer to [Operation after Deviation/Out of Range was Detected].

[Partition Paper when Deviation/Out of Range was Detected]

Configure the partition paper insertion settings if paper is output that does not meet the standards required.

For details, refer to [Partition Paper when Deviation/Out of Range was Detected].

[Automatic Reprint when Deviation/Out of Range was Detected]

Configure the reprint settings if paper is output that does not meet the standards required.

For details, refer to [Automatic Reprint when Deviation/Out of Range was Detected].

[Output Tray for Out of Range]

Configure the settings for the output destination of paper that does not meet the standards required.

For details, refer to [Output Tray for Out of Range].

[Create Auto Inspection Report]

Configure the settings for creating reports of automatic inspection results.

For details, refer to [Create Auto Inspection Report].

[Create Report of Completed Job]

Configure the settings for creating reports of inspection results that are within the standards.

For details, refer to [Create Report of Completed Job].

[Automatic Inspection Level Setting]

Configure the inspection standards settings for automatic inspections.

For details, refer to [Automatic Inspection Level Setting].

[Reference Image Automatic Deletion]

Configure the settings for automatic deletion of reference images created in automatic inspections.

For details, refer to [Reference Image Automatic Deletion].

[Reference Image Type Selection]

Select a reference image type.

It is recommend that you set to [RIP Data].

Inspection Enhancement Kit UK-311 is required to use this function.

For details, refer to [Reference Image Type Selection].

[Setting for Inspect. Of Excluded Areas]

Configure the default of the Inspection Excluding Area.

For details, refer to [Setting for Inspect. Of Excluded Areas].

[Counted Error by Each Level]

Counts the detected stains and omissions by level, and displays the results in the automatic inspection result report.

For details, refer to [Counted Error by Each Level].

[Text for OCR]

Sets the target characters to be read by OCR. For details, refer to [Text for OCR].

[Output Tray for Reference Image Job]

Sets the paper output destination for the reference image job. For details, refer to [Output Tray for Reference Image Job].