Loading Paper Into the Main body tray
Overview
Load paper into the Main body tray.
Change the paper settings of the tray to be used when loading the paper of different specifications.
Reference
- For more details on paper configuration, refer to [Paper Setting].
Procedure
1
Pull out the paper replenishing tray and open the Feed roller.
Proceed to Step 5 when loading paper of the same size.
Proceed to Step 2 when loading the paper of different sizes.
2
Hold down the Side guide lock release lever and open wide the Side guides.
Move it using the size indicator on the Tray bottom plate as a reference.
3
Open up the Rear guide plate.
When moving the Rear guide plate to the right, grip the top section of the Rear guide plate and slide it while pressing down.
When moving the Rear guide plate to the left, hold the bottom section of the Rear guide plate and slide it while pressing down.
NOTICE
- When moving the Rear guide plate to the right, it will not slide smoothly if you are not pressing if down. However, when moving to the left, if you hold the top section of Rear guide plate, it will not slide smoothly.
- If you forcibly try to move Rear guide plate, it may be damaged.
4
Load the paper so that it is flush against the right side of the tray.
Load the paper with the print side facing down.
NOTICE
- Do not load more paper than can be loaded in the tray. For details about the number of loadable sheets, refer to Machine Part Names and Specifications.
- Exercise care not to exceed the maximum height displayed on the Side guides. Doing so can cause a paper jam.
- If you are loading the paper up to near the height limit, the paper may shift if you push the tray back into the machine using excessive force. Do not apply unnecessary force when pushing the tray back into the machine.
5
Hold down the Side guide lock release lever and place the Side guides against the paper.
6
Place the Rear guide plate against the paper.
NOTICE
- Make sure that the Rear guide plate is placed firmly against the paper. If there is a gap between the Rear guide plate and the paper, the machine will not be able to properly detect the correct paper size, which may lead to a paper feed device failure.
7
Firmly push the tray all the way in.
The remaining paper amount indicator changes from "
" to "
".
in the upper-right of a page, it turns into 
and is registered as a bookmark.