Loading Paper Into Large Capacity Unit LU-202XLm

Load paper into the Large Capacity Unit LU-202XLm.

When loading paper of different specifications, change the paper setting of the large capacity unit.

If the Paper Feed Unit PF-707m is also mounted, it is recommended that the Paper Feed Unit PF-707m be used to feed the coated paper.

If any failures in the paper feed occur due to the type, size or weight of the paper being used, as shown in the figure below, attaching the provided weights to the pick-up roller may help to improve the paper feed performance. When loading paper of weight over 256 g/m² / 68 lb Bond into the Large Capacity Unit LU-202XLm, attach 2 weight plates in advance, and the number of weights.

Reference

• For details about the paper setting, refer to [Paper Setting].

1

Open the Top door (left) and the Top door (right).

The Tray bottom plate goes down.

Proceed to Step 4 when loading paper of the same size.

Proceed to Step 2 when loading the paper of different sizes.

NOTICE

• The tray bottom plate will not descend if the power supply of the machine is not first turned on. Turn the Sub power switch on. For details, refer to Switch on Power Supply of the System.

2

Adjust the position of the left Side guides.

Rotate the Side guide lock knobs (4 locations) of Side guides (left) counterclockwise and loosen them.

Move the two Side guides (left) so that they align with the size indicators provided on the guide plate.

Rotate the Side guide lock knobs (4 locations) of Side guides (left) clockwise and lock them.

3

Adjust the position of Rear guide.

Hold down the Rear edge guide lock release lever and move the Rear guide so that it aligns with the size indicator of Tray bottom plate.

4

Load the paper with the print side facing up.

5

Press the Tray bottom plate lowering button.

NOTICE

• It will not work even if you press the Tray bottom plate lowering button if the power supply of the machine is not first turned on. Turn the Sub power switch on. For details, refer to Switch on Power Supply of the System.

6

Repeat Steps 4 and 5 until the tray no longer descends.

NOTICE

• Exercise care not to exceed the lines of paper upper limit label displayed on Side guides (left) when loading the paper.
• Check that the Rear guide is flush against the set paper. Having a gap between Rear guide and paper or having too short a gap can lead to paper jams and malfunctions.

7

Close the Top door (right) and Top door (left).

The remaining paper amount indicator changes from "" to "".