Loading Paper Into Paper Feeder Unit PF-602m
Overview
Load paper into the Paper Feeder Unit PF-602m.
Change the paper settings for the tray being used when loading paper of different specifications.
Reference
- For more details on paper configuration, refer to [Paper Setting].
Procedure
1
Pull out the paper replenishing tray.
Proceed to Step 2 when loading the paper of different sizes.
Proceed to Step 5 when loading paper of the same size.
NOTICE
- The tray cannot be pulled out if the power supply of the machine is not first turned on. Turn the Sub power switch on. For details, refer to Switch on Power Supply of the System.
- Do not pull out multiple trays at once. Doing so may cause the machine to topple over.
2
Open out the Side guides and the Rear guide plate.
Rotate Side guide lock knobs of Side guides (4 locations) counterclockwise and loosen them.
Hold down Side guide lock release lever of Side guides and Rear edge guide lock release lever of Rear guide plate and open out the guides.
NOTICE
- When moving the Side guides, hold the front side Side guide lock release lever and back side handles. Trying to move just with the front side Side guides may misalign the position of Side guides.
3
Hold down the Side guide lock release lever of Side guides and move the Side guides in line with the size indicator of Tray bottom plate.
4
Rotate Side guide lock knobs of Side guides (total 4 locations) clockwise and lock them.
5
Load the paper with the print side facing up.
Load the paper so that it is aligned with the left side of the tray.
NOTICE
- Exercise care not to exceed the maximum stack height lines displayed on the tray Side guides when loading the paper.
- Small size guides are attached to two Side guides. Open this only when loading paper of width less than 182 mm / 7.17". For details about how to use the Small size guides, refer to Loading Small Sized Paper Into Paper Feeder Unit PF-602m.
6
Place the Rear guide plate flush against the paper.
Hold down Rear edge guide lock release lever of Rear guide plate and place against the paper.
NOTICE
- Make sure that Rear guide plate is placed firmly against the paper. If there is a gap between the Rear guide plate and the paper, the machine will not be able to properly detect the correct paper size, which may lead to a paper feed device failure.
7
Firmly push the tray all the way in.
The remaining paper amount indicator changes from "
" to "
".
NOTICE
- Do not apply excessive force when pushing the tray back in. There may be an unexpected impact on the machine because of the weight of the tray or paper causing the malfunction.
in the upper-right of a page, it turns into 
and is registered as a bookmark.