[Punch Registration Loop Adj.]
Overview
Adjust the amount of paper loop of the registration roller, and straighten the bends and wrinkles of the paper.
Perform this function when the punch position is tilted.
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required items | Finisher FS-532 with Z Folding Unit ZU-608 mounted | ||
Setting items | [Back on Top Output] | Adjusts the loop amount for Back on Top Output. | |
[ADU Feed] | Adjusts the loop amount for ADU Feed. | ||
[Current Data] | Displays the current adjustment value. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to [Current Data]. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Punch Registration Loop Adj.] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Punch Registration Loop Adj.] | |||
Procedure
1
Select [Back on Top Output] or [ADU Feed].
2
Press [Print Mode].
3
Load the desired paper into a paper tray, and select that paper tray.
[Output Setting] is automatically set to [Punch].
4
Press Start on the Control panel.
A sample is output.
5
Check the inclination of the punch position.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
To change [Current Data], use [+ / -] to select the plus or minus of the numeric value, and press [Set].
[Adj. Range:-20~+20 1step = 0.8mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.