[Horiz. Position Adj.(FD)]
Overview
Adjust the distance between the edge of the punched output paper and the center of the punch holes, and arrange the finishing.
Perform this function when the punch position is misaligned.
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required items | Finisher FS-532 with Z Folding Unit ZU-608 mounted | ||
Setting items | [Current Data] | Displays the adjustment value for horizontal position adjustment. | |
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to [Current Data]. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Horiz. Position Adj.(FD)] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Horiz. Position Adj.(FD)] | |||
Procedure
1
Press [Print Mode].
2
Load the desired paper into a paper tray, and select that paper tray.
[Output Setting] is automatically set to [Punch].
3
Press Start on the Control panel.
A sample is output.
4
Check distance "a" from the edge of the output paper to the center of punch holes.
Standard value: a = 10.5 mm to 5 mm
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Use the on-screen keypad to enter the numeric value.
To change [Current Data], use [+ / -] to select the plus or minus of the numeric value, and press [Set].
Punch position at paper edge: [-] Far [+] Close
[Adj. Range:-50~+50 1step = 0.1mm]
7
Repeat steps 1 to 6 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.