Adjustment | [Vert. Position Adj.(CD)]

[Vert. Position Adj.(CD)]

Adjust the distance between the center of the punched output paper and the center of the punch holes, and arrange the finishing.

Perform this function when the punch position is misaligned.

Category		Adjustment / Maintenance
Location	Machine	Touch Panel
	Printer driver	-
	Application	-
Required items		Finisher FS-532 with Z Folding Unit ZU-608 mounted
Setting items		[Offset for All Size]	Adjusts the punch position common to all the paper sizes.
		Paper size selection key	Selects the paper size to adjust.
		[+] / [,]	Switches the paper size page.
		Keypad	Used to enter numeric values.
		[Clear]	Returns the entered numeric value to "0".
		[Set]	Sets the numeric value entered using the keypad to the selected setting item.
Remarks		-
Reference		-
Screen access		Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Vert. Position Adj.(CD)]
		Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Z-Folding Unit Adjustment] - [Punch Adjustment] - [Vert. Position Adj.(CD)]

Press the selection key of the paper size to adjust.

Press [Print Mode].

Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.

[Output Setting] is automatically set to [Punch].

Press Start on the Control panel.

A sample is output.

Check distance "a" from the center of the output paper to the center of punch holes.

Standard value: a = 0 mm to 2 mm

If any adjustments are required, press [Exit PrintMode] to return to the setting screen.

Use the on-screen keypad to enter the numeric value.

To change [Current Data], use [+ / -] to select the plus or minus of the numeric value, and press [Set].

Punch position at paper edge: [-] Forward [+] Backward

[Adj. Range:-50~+50 1step = 0.1mm]

Repeat steps 2 to 7 until the desired result is obtained.