[Restart Timing Adjustment]
Overview
Adjust the image lead-edge position (image writing position) in the paper feed direction when printing.
An image can be printed at the correct position by adjusting the reference position of the print side.
NOTICE
- The following setting is required to use this function.
- Perform [FD-Mag. Adjustment] in [Printer Adjustment].
Reference
- For details about [FD-Mag. Adjustment] in [Printer Adjustment], refer to [FD-Mag. Adjustment].
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel, Control Panel | |
Printer driver | - | ||
Application | - | ||
Required options | - | ||
Required items | - | ||
Setting items | [Side1] | Adjusts the image lead-edge position in the feed direction of the front side. | |
[Side2] | Adjusts the image lead-edge position in the feed direction of the back side. | ||
Adjustment target selection key | Select the adjustment target. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the on-screen keypad or the Keypad of the Control panel to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Machine Adjustment] - [Printer Adjustment] - [Restart Timing Adjustment] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Printer Adjustment] - [Restart Timing Adjustment] | |||
Procedure
1
Select [Side1] or [Side2].
2
Press the adjustment target selection key to adjust.
3
Press [Print Mode].
4
Press [1->1].
5
Load A3 w or 11 e 17 w paper in the paper tray for adjustment selected in step 2, and select that paper tray.
6
Press Start on the Control panel.
A chart is output.
For details about the 
mark that is printed on the front side of the chart refer to About Charts.
7
Check the restart timing.
Standard value: 20 mm ^ 0.5 mm
8
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
9
Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[All Trays Offset]: [Adj. Range:-45~+45 1step = 0.1mm]
Others: [Adj. Range:-30~+30 1step = 0.1mm]
10
Repeat steps 3 to 9 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.