What Is [Program Job]?
Program Job is a function that merges multiple copy jobs scanned in different settings, and prints them as a single job.
A paper tray can be set for each job, so it also possible to merge jobs of different paper sizes and paper types.
Note the following when setting [Program Job].
- Automatically set to [Separate Scan].
- For Punch, the same setting is applied to all jobs. The setting cannot be configured for each job.
- To change the punch setting for each job, load the punched sheets in a paper tray, and set a paper tray for each job. Set the paper tray loaded with the punched sheets to [Pre-Punched] in [Paper Setting].
- Up to 10,000 pages can be scanned.
- [Program Job] cannot be registered in the Copy Mode Memory.
Tips
- Staple must be set to all jobs or each scanned job.
Was this information useful?
Thank you.
in the upper-right of a page, it turns into 
and is registered as a bookmark.