[Gutter Slit Position]
Overview
Adjust the gutter slit position. Even if the numeric value is changed, the gutter width remains unchanged.
Tips
- When there is 1 gutter slit, the numeric value of [Gutter Slit Position] is applied to the slit position.
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required options | Trimmer Unit TU-510 with Trimmer Unit TU-504 mounted | ||
Required items | - | ||
Setting items | [Gutter Slit Front] | Adjusts the gutter slit position in the front side. | |
[Gutter Slit Rear] | Adjusts the gutter slit position in the rear side. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [1x1-1x3/1x1-3x3 Mode] - [Gutter Slit Position] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [1x1-1x3/1x1-3x3 Mode] - [Gutter Slit Position] | |||
Procedure
1
Press [Print Mode].
2
Load the desired paper into a paper tray, and select that paper tray.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
3
Press Start on the Control panel.
A sample is output.
4
Check the gutter slit position.
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Press [Gutter Slit Front].
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the slit position to the front side, (+) To move the slit position to the rear side
[Adj. Range:-30~+30 1step = 0.1mm]
8
Press [Gutter Slit Rear].
9
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the slit position to the rear side, (+) To move the slit position to the front side
[Adj. Range:-30~+30 1step = 0.1mm]
10
Repeat steps 1 to 9 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.