[FD Perforation Position]
Overview
Adjust the perforation position in the feed direction.
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required options | Trimmer Unit TU-510 with Perforation Unit PE-101 mounted | ||
Required items | - | ||
Setting items | [FD Perforation Front] | Select the perforation position (front side) in the feed direction. Adjust this when shifting occurs at the second position before the perforation in the feed direction with [Four Edge Trim Mode]. | |
[FD Perforation Rear] | Select the perforation position (rear side) in the feed direction. Adjust this when shifting occurs at the second position behind the perforation in the feed direction with [Four Edge Trim Mode]. | ||
[FD Perforation Length] | Select the jump position before a perforation in the feed direction. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [Four Edge Trim Mode] - [FD Perforation Position] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [Four Edge Trim Mode] - [FD Perforation Position] | |||
Procedure
1
Press [Print Mode].
2
Load the desired paper into a paper tray, and select that paper tray.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
3
Press Start on the Control panel.
A sample is output.
4
Check the perforation position.
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Press [FD Perforation Front].
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the perforation position to the front side, (+) To move the perforation position to the rear side
[Adj. Range:-30~+30 1step = 0.1mm]
8
Press [FD Perforation Rear].
9
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the perforation position to the rear side, (+) To move the perforation position to the front side
[Adj. Range:-30~+30 1step = 0.1mm]
10
Press [FD Perforation Length].
11
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the jump position to the lead side (+) To move the jump position to the rear edge
[Adj. Range:-30~+30 1step = 0.1mm]
12
Repeat steps 1 to 11 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.