[2-Side Slit Position]
Overview
Adjust the 2-side slit position in the paper feed direction.
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required options | Trimmer Unit TU-510 | ||
Required items | - | ||
Setting items | [2-Side Slit Front] | Adjusts the trim position in the front side. | |
[2-Side Slit Rear] | Adjusts the trim position in the rear side. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [1x1-1x3/1x1-3x3 Mode] - [2-Side Slit Position] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [1x1-1x3/1x1-3x3 Mode] - [2-Side Slit Position] | |||
Procedure
1
Press [Print Mode].
2
Load the desired paper into a paper tray, and select that paper tray.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
3
Press Start on the Control panel.
A sample is output.
4
Check the 2-side slit position.
5
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
6
Press [2-Side Slit Front].
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To cut a small quantity, (+) To cut a large quantity
[Adj. Range:-30~+30 1step = 0.1mm]
8
Press [2-Side Slit Rear].
9
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To cut a small quantity, (+) To cut a large quantity
[Adj. Range:-30~+30 1step = 0.1mm]
10
Repeat steps 1 to 9 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.