Loading Envelopes Into Paper Feeder Unit PF-812

Load envelopes into Paper Feeder Unit PF-812.

- Available size

Widthwise 210 mm to 245 mm, lengthwise 210 mm to 375 mm / Widthwise 8.27" to 9.65", lengthwise 8.27" to 14.76"

- Recommended sizes

- Load capacity

100 sheet

The height difference on the top of the envelope must be 10 mm / 0.39" or less.

NOTICE

• Envelopes can only be loaded into the Lower tray (Tray 3) of the 1st paper feeder unit.

1

Pull out the tray to load envelopes into.

NOTICE

• The tray cannot be pulled out if the power supply of the machine is not first turned on. Turn the Sub power switch on. For details, refer to Switch on Power Supply of the System.
• Do not pull out multiple trays at once. Doing so may cause the machine to topple over.

2

Load envelopes into the tray with the print side facing up.

Load the envelopes against the top of the tray so that the open flaps are on the right side.

If the Side auxiliary guides is mounted, remove it. You do not need to remove the positioning screws.

3

Align the Side guides (left) of the tray with the envelopes, turn the Side guide lock knobs, and fix it.

4

Align the Rear guide plate of the tray with the envelopes.

5

Firmly push the tray all the way in.