Using a Computer to Print a Hold Job

You can print a hold job using Job Centro.

1. Start Job Centro and log in to the machine. (Refer to Starting Job Centro.)

   The [Job Centro] screen is displayed.

2. Click the [Hold Job] tab and select the job to be print.

   • In [Job Type], [Print] (temporarily holding print job from the printer driver) / [Copy] (temporarily holding copy or scan data from the main body) is displayed.

   • It is possible to select multiple jobs.

3. Click [Print].

   You can alternately click [Hold Job] - [Print] in the [Job Operations] menu.

4. Select [Print Mode] on the [Print] screen, enter [Number of Copies], then click [OK].

   • Selecting [Normal] prints data by the number of sets that is specified for the job.

   • Selecting [Proof] prints one set of data only to enable the print results to be viewed.

   • Selecting [Proof(1st Sheet)] prints only the first page to enable the print results to be viewed.

   • Selecting [Wait] sets the job to the output stop state as a reserved job.

   

   To delete the job at the time of outputting, add a check mark to [With Job Delete].

   • If multiple jobs are selected in step 2, data is printed by one set. The number of copies cannot be specified.

   

   • To delete the job at the time of outputting, add a check mark to [With Job Delete].

   The specified job is output.