Vertical Position Adj.(CD): Adjusting the Depth Direction of Punch Hole Positions
Adjust misalignment of punch position with the center of punched output in Z-Folding Unit ZU-608 mounted on Finisher FS-532.
Objects of adjustment:
Offset for All Size, A3 
, B4 , SRA4 , A4 , A4 
, B5 , B5 , A5 , 11 
17 , 8.5 14 , 8.5 11 , 8.5 11 , 5.5 8.5 , 5.5 8.5 , 8 13 , 8K , 16K , 16K , 9 11
If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Z-Folding Unit Adjustment], [Punch Adjustment], and [Vert. Position Adj.(CD)] in sequence.
Select the size to be adjusted using [
] or [
]. 
Press [Print Mode].
Load the paper size selected in step 3, then select that tray key.
For [Output Setting], [Punch] is automatically selected.
Press Start on the control panel.
A sample pattern will be output.
Measure the difference (a) between the center line of printed paper to the center position of punch holes.
Allowance: a = 0 mm ± 2 mm
[1] Center of paper, [2] Center of punch hole
Press [Exit PrintMode] to return to the [Vertical Position Adjustment(CD)] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment Range: -50 ([Forward]) to +50 ([Backward]) (1 step = 0.1 mm)
Press [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 4 to 10 until the desired result is obtained.
Press [Return].
The screen returns to the [Punch Adjustment Menu] screen.